Prime Operation - After Air In Line Alarm - CME BodyGuard 121 Twins Operator's Manual

4. When the display screen shows the existing program press
key to prime the administration set.
Warning:
5.
Press
6. The display screen will show a progress bar indicating the
priming operation.
7. Once the priming has completed, the display will change back to the previous screen the pump
was in before priming.

Make certain that all air is removed from the IV line before connecting to the patient. To perform
another priming operation, in case all air was not cleared from the set, open a door and close it,
then follow the same instructions to prime the set once more until no air is left in the set.
Prime Operation – After Air in Line Alarm
Press
1.
2. Disconnect IV tubing from patient.
3.
Press
Warning:
4.
Press
5. The display screen will show a progress bar indicating the
priming operation.
6. When priming has completed make certain that all air is removed from the IV line.
7. Connect IV line to the patient and press

NOTE: Same tests should be performed for channel 2
to channel 2, use the Channel select key
program data on channel two.
Ensure the set is not connected to the patient!!!
to start priming. You may stop priming at any time by pressing
to mute the alarm.
once.
Ensure the set is not connected to the patient!!!
to start priming. You may stop priming at any time by pressing
PRIME
DISCONNECT PATIENT
Press OK to Start
PRIME
0
PRIME
DISCONNECT PATIENT
Press OK to Start
PRIME
0
to resume program.
. User may prime channel one while setting
.
10ml
20
.
10ml
20
. To change the display
29