Check The Boom Wear Pads - Genie GTH-1048 Service Manual

Service Manual
Checklist B Procedures
3 Using a mild solvent, carefully wash the cap
venting system. Dry using low pressure
compressed air. Repeat this procedure
beginning with step 2.
4 Install the fuel tank cap onto the fuel tank.
5 Remove the breather cap from the hydraulic
tank.
6 Check for proper venting. The cap is
pressurized to 3 psi.
Result: Air passes through the breather cap.
Proceed to step 8.
Result: If air does not pass through the cap,
clean or replace the cap. Proceed to step 7.
Note: When checking for positive tank cap venting,
air should pass freely through the cap.
7 Using a mild solvent, carefully wash the cap
venting system. Dry using low pressure
compressed air. Repeat this procedure
beginning with step 6.
8 Install the breather cap onto the hydraulic
tank.
30
B-8 C heck the Boom W ear Pads
B-8

Check the Boom Wear Pads

Genie specifications require that this procedure be
performed every 250 hours of operation.
1 Extend the boom until the wear pads are
accessible.
Note: It may be necessary to remove the wear pad
retainer plates to expose the wear pads.
2 Inspect the end of each upper wear pad.
Result: The wear pad grooves are visible on
the end of the wear pad.
Result: The grooves on the end of the wear
pad are no longer visible. Replace both wear
pads. Refer to the Repair Procedure, How to
Replace the Boom Wear Pads.
1 wear pad groove
GTH-1048 • GTH-1056
March 2016
Part No. 123701
Courtesy of Crane.Market