How To Remove The Joystick - Models With Dual Joysticks; How To Remove The Brake Pedal Assembly - Genie GTH-1048 Service Manual

March 2016
How to R emove the Joy stick - Models with Dual J oys ticks
How to Remove the Joystick -
Models with Dual Joysticks
1 Disconnect the battery from the machine.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
2 Remove the fasteners securing the joystick
mount panel to the side console.
3 Tag and disconnect the joystick wire harness
from the machine.
4 Tag, disconnect and plug the hoses from
ports 1, 2, 3, 4 and P of the joystick. Cap the
fittings.
5 Locate the tee fitting which joins together the
hydraulic hoses from port T of both joysticks
to the tank return hydraulic hose.
6 With the tee fitting above the top of the
hydraulic tank, tag, disconnect and plug the
tank return hydraulic hose from the tee fitting.
Cap the fitting.
Note: Removing the hydraulic hose from port T of
the joystick with the joystick below the hydraulic oil
level in the hydraulic tank will result in excessive
hydraulic fluid leaking from the hose. Do not
disconnect the hose from the port if the joystick is
below the hydraulic oil level in the hydraulic tank.
7 Remove the fasteners securing the joystick to
the mount panel. Remove the joystick.
Part No. 123701
Operator's Compartment
How to R emove the Brake Pedal Ass embly
How to Remove the Brake Pedal
Assembly
1 Disconnect the battery from the machine.
2 Fully press and release the brake pedal a
minimum of 10 times to release the hydraulic
pressure in the brake system.
3 Tag, disconnect and plug the hydraulic hoses
at ports BP and BT of the secondary hydraulic
manifold. Cap the fittings.
4 Follow the hydraulic hose from port A of the
brake pedal manifold to the brake manifold.
Tag, disconnect and plug this hydraulic hose
at the brake manifold. Cap the fitting.
5 Remove the fasteners securing the brake
pedal assembly to the dash frame.
6 Gently rotate the brake pedal in an upwards
direction and slowly move the brake pedal
assembly away from the dash frame while
feeding all loose hoses through the opening of
the chassis.
GTH-1048 • GTH-1056
Service Manual
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
Courtesy of Crane.Market
75