1-Series Sensor Replacement - Honeywell BW Solo User Manual

2.
If not already done, place the metal insert inside the sealing ring, and then place that
combination over the sensor, followed by the sensor frame over the spacer. Align the frame
so that it fits properly around the audible alarm port. Tighten the screws to hold the frame in
place. Note: Do not overtighten.
Metal
Insert
Sealing
Ring
Install a new filter over the sensor before replacing the cover.

13.4.2. 1-Series Sensor Replacement

Some Series 1 sensors are shipped with a jumper that connects two of the pins. This jumper must
be removed before installing the sensor. Turn the sensor upside-down, and slide the jumper off of
the sensor's pins. Properly dispose of the jumper.
Honeywell BW Solo User Manual
Sensor
Jumper
Bottom Top
View View
Jumper
Attached
Sensor
Frame
IMPORTANT!
Jumper
Removed
40
Jumper
Sensor