Honeywell BW Solo User Manual page 18

Honeywell BW Solo User Manual
4.
Turn over the battery door, remove the old battery, and then press the new battery into place.
Note the polarity (+/- orientation).
5.
Turn over the battery door and align the battery over its compartment. Then press it into the
instrument. Insert the screw and lock washer.
6.
Tighten the screw. Do not overtighten the screw.
7.
Turn on the instrument to make sure the battery was properly installed.
After a battery is inserted, the screen shows a blinking battery icon. The battery is being
conditioned (depassivation), and it typically takes about 30 seconds. If more time is required,
the blinking battery icon continues to be shown. When depassivation is complete, there is no
battery icon on the screen. The instrument can now be turned on.
Used batteries must not be disposed of as general industrial or domestic waste. They should be
disposed of through suitable disposal facilities.
IMPORTANT!
18