Kenmore SENSOR SMART Owner's Manual And Installation Instructions page 30

CHOOSING MODIFIERS
AUTO DRYNESS LEVEL
AUTO DRYNESS LEVEL saves you
time by providing the best drying re-
sults in the shortest time. This can
help you save money on utility bills
and reduce the risk of fabric damage.
Press the AUTO DRYNESS LEVEL pad
once to select NORMAL DRY. Use this
setting for most loads. Drying time varies
according to type of fabric, size of load,
and dryness setting.
• Select the cycle that matches the fabric
in your load. The display will show the
estimated time (in minutes) to remove
80% of the moisture from the load. It will
then change to show the actual number
of minutes remaining.
• At the end of the cycle, feel the dried
clothes. If they are damp, select MORE
DRY the next time you do a similar load.
If they are overdried, select LESS DRY
the next time you do a similar load.
Press the AUTO DRYNESS LEVEL pad
until the indicator light next to the desired
level glows.
• Dryness is determined by an electronic
sensor that "feels" the amount of
moisture in clothes as they pass over it.
When the dryness selected is reached,
the dryer goes into a Cool Down
period. The length of the Cool Down
period depends on load size and dry-
ness setting.
• The END OF CYCLE SIGNAL sounds
once the cycle is completed, if selected.
• If you do not unload the dryer, it goes
into WRINKLE GUARD
(see page 29).
• Can also be used to finish drying cloth-
ing items that are still slightly damp at
the end of the cycle.
30
® III, if selected.
TIMED DRY
Use TIMED DRY to select a specific
amount of time for your load.
• Once you have selected your cycle,
press MORE TIME or LESS TIME to
adjust time.
• The heating cycle is followed by a
Cool Down period of up to 10 minutes.
• The END OF CYCLE SIGNAL sounds
once the cycle is completed, if selected.
NOTE: At the end of the cycle, the
dryer will go into WRINKLE GUARD
if selected.
END OF CYCLE SIGNAL
Your dryer sounds a signal when
a drying cycle is finished.
The signal is helpful when you are drying
permanent press, synthetics, and other
items. These items should be removed
from the dryer as soon as it stops to
prevent wrinkles.
• The sound level of this tone can be
adjusted or turned off by pressing the
END OF CYCLE SIGNAL pad. The tone
you will hear at the end of the cycle will
sound as the pads are pressed.
® III,