Kenmore SENSOR SMART Owner's Manual And Installation Instructions page 26

CHOOSING CYCLES
(SELECT CYCLE/TEMPERATURE Pads)
Use these pads to choose the right drying
cycle for the type of load you are drying.
Each time you select a cycle, the preset
cycle settings are displayed.
NOTE: A range of heat is automatically
set for the type of fabric selected. See
page 28 for suggested dryer settings for
your load type.
COTTON
Use this cycle to get high heat for heavy
fabrics.
NORMAL
Use this cycle to get medium high heat for
sturdy fabrics.
PERMANENT PRESS
Use this cycle to get medium heat for syn-
thetic fabrics and no-iron finishes.
KNIT/CASUAL
Use this cycle to get low heat for wash-
able knit fabrics.
26
ULTRA DELICATE
Use this cycle to get extra low heat for
drying heat-sensitive fabrics.
EXPRESS DRY™
Use this cycle to get 16 minutes of high
heat followed by a 7 minute Cool Down
period. Use for smaller loads or for loads
needed in a shorter time period.
AIR DRY
Use this cycle to tumble heat sensitive
fabrics without heat (see page 27).
CUSTOM SET
CUSTOM SET allows you to select the
cycle, options and modifiers you use
most frequently and store them in
memory for future use by pressing
just two pads: CUSTOM SET and
START.
To custom set a cycle:
STEP 1. Select Cycle.
STEP 2. Select the desired Options.
STEP 3. Select the desired Modifiers.
STEP 4. Press and hold CUSTOM SET
until a beep sounds (approximately 3
seconds).
STEP 5. Press START.
The Custom Set cycle is now stored for
future use. To reuse, select CUSTOM
SET and press START.
TOUCH UP
Use this cycle to smooth cleaned, wrin-
kled synthetic and permanent press
clothes that have been packed or stored
(see page 29).