Kenmore SENSOR SMART Owner's Manual And Installation Instructions page 23

REVIEW INSTALLATION
CONGRATULATIONS,
Take a few minutes to complete
this checklist. It will help assure you
INSTALLATION IS COMPLETE
that you have a proper installation
and increase your satisfaction with
your Kenmore ELITE™ dryer.
Check that all parts you removed
from the parts packages are now
installed.
Ensure that dryer is positioned in its
final location. Make sure vent is not
crushed or kinked.
FINAL STEPS
Plug into a grounded 3 prong outlet.
Wipe the interior of the drum
thoroughly with a damp cloth to
remove any dust.
Remove the blue protective film on the
console and any tape remaining on
dryer.
Ensure that dryer is level by placing
a level on top of the dryer. Check side-
CONGRATULATIONS,
to-side first, then check front-to-back. If
INSTALLATION IS COM-
dryer is not level, adjust the legs up or
PLETE
down.
Check to make sure you have all
the tools you started with.
To remove air from the gas line, set the
dryer on a full heat cycle (not the AIR
DRY cycle) for 20 minutes. After five
minutes, open dryer door. The burner
should have ignited during these five
minutes. If you do not feel heat, turn
the dryer off and WAIT 5 MINUTES.
During these 5 minutes check to be
sure dryer gas supply valve is open.
Repeat steps above. If the burner still
does not ignite, see "TROUBLE-
SHOOTING".
Read the rest of this manual to fully
understand your new dryer.
23