Using The Waypoint Feature - Epson Trume TR-MB7 User Manual

MB73 (TR-MB7) User's Guide

Using the Waypoint Feature

Registering a base point
You need to register the base point in advance to use the Waypoint feature.
A
Move to the location you want to use as the base point
B
Register the base point (Reference Value Setting)
"About the Reference Value Setting" on page 121
U
Note:
When Reference Value Setting is complete, make sure that the small second hand points to + (success). If it points to -
(failure), registering the base point is not complete.
c
Important:
After registering the base point, do not make a base point setting again until you have finished using the
Waypoint feature. The base point has been changed to an unintended location.
<Example> When performing basic altitude calibration, the location of the base point changes
Changing the Distance Range
You can change the range (maximum value) for the linear distance displayed in three stages. Set the Distance Range
according to the distance to the base point.
Distance Range
0 to 9,900 m (9.9 km)
0 to 99,000 m (99 km)
0 to 990,000 m (990 km)
Waypoint Feature (COM)
Dial display
100
1000
10000
97
Minimum Distance While
Measuring
100 m (0.1 km)
1,000 m (1 km)
10,000 m (10 km)