Epson Trume TR-MB7 User Manual page 131

MB73 (TR-MB7) User's Guide
Adjusting time
Trouble
The watch successfully
received GPS satellite signals,
but the time is out of sync
I am not sure if my watch is
receiving leap second
information
Troubleshooting
The watch may have been set to a different time zone to the current time
zone.
You need to set the time zone manually.
"Setting the Time Zone" on page 59
U
The Daylight Saving Time (DST) being used at your current location may
differ from the DST setting on the watch.
Check the Daylight Saving Time (DST) being used at your current location,
and then reset the DST on your watch.
"Setting Daylight Saving Time" on page 63
U
Daylight Saving Time (DST) is not set automatically.
You need to set it manually.
"Setting Daylight Saving Time" on page 63
U
The hand position may be deviated.
Calibrate the deviation in the hand position.
"Correcting Misalignment of the Hands or the Date" on page 141
U
The time zone you are traveling to may have been changed since
January 2017.
You need to set the changed time zone manually.
"Setting the Time Zone" on page 59
U
Check if you are receiving leap second information.
"Checking the reception results for leap second information" on
U
page 56
<When receiving leap second information>
The leap second is automatically inserted (or removed) when it is time to use
the leap second.
<When not receiving leap second information>
Leap second information is received automatically. This is performed within
18 minutes after successfully receiving a GPS satellite signal for one of the
following features.
"Adjusting the Time" on page 45
U
"About the Automatic Time Reception Feature" on page 51
U
If the watch fails to receive leap second information, it will try again the
following day or the next time a GPS satellite signal is received successfully.
The watch continues to attempt to receive leap second information until it
succeeds.
131
Causes and Solutions