Epson Trume TR-MB7 User Manual page 49

MB73 (TR-MB7) User's Guide
C
Hold down the B button for approximately five seconds, and release when the small
second hand points to 30 seconds position
After holding down the B button for three seconds, the small second hand points to 0 seconds position, but you
need to continue to hold down the button.
The indicator hand points to M.
D
With the dial facing straight up, wait until the reception result is displayed (the small
second hand points to + or -)
Receiving a signal takes approximately 20 seconds to two minutes.
When receiving signals
The small second hand and the outside numbers (0/3/6/9) indicate the number of GPS satellites acquired.
<When the number of satellites acquired is 6>
<When the number of satellites acquired is 7>
Note:
❏ You need to acquire at least four GPS satellites to acquire positional information.
However, reception may fail even if the watch indicates four or more satellites.
❏ To stop receiving signals, press and release the B button.
Adjusting Time (Receiving GPS Satellite Signals) (TIME)
5 sec.
49