Epson Trume TR-MB7 User Manual page 132

MB73 (TR-MB7) User's Guide
Stopwatch
Trouble
Cannot start measuring
The center hand stops while
measuring
The center hand/
measurement hand (short
hand/long hand) has
returned to 0 seconds
position
Troubleshooting
Time adjustment (receiving GPS satellite signals) is being performed.
Wait until adjusting the time is complete, or press and release the B button to
stop receiving the signal.
If you do not operate any of the buttons within 10 minutes, the center
hand stops at 0 seconds position.
Measuring continues.
By pressing Split (B button) or stop measuring (C button) you can check the
measurement time at the time of operation.
"Using the Stopwatch" on page 68
U
The time that can be measured has been exceeded.
"Using the Stopwatch" on page 68
U
132
Causes and Solutions