Receive; Power Off; Status Indicators And Audible Alert Tones; Scan Modes - Maxon SM-3000 Enduro series Operating Instructions Manual

NOTE: The LED will glow red when transmitting. This indicator should be on continuously while the P-T-T button is being pressed
and the radio is transmitting..

Receive

When you have finished transmitting, release the P-T-T button to receive.

Power Off

When finished transmitting, receiving, monitoring, etc., turn the radio off by rotating the on/off-volume control fully counter-
clockwise, to the detent position.

Status Indicators and Audible Alert Tones

Your SM-3000 Enduro series has a sophisticated microprocessor control which provides a series of audible alert tones.
Upon initial power up, a quick melody indicates that the self-test of
the microprocessor functions has been completed satisfactorily. A
series of tones may be sounded with any of the following conditions:
· Attempt to transmit on a channel set for receive only
· Attempt to transmit on a channel that is already in use when busy channel lockout has been programmed into the radio *
· Transmitting time has exceeded time-out timer programmed length *
· Selecting a channel with no programmed frequency
* Indicates a function that is initially programmed into the radio by your Maxon Dealer.
NOTE: All audible tones can be programmed off for silent operation.
Status Description
Normal Power On - Ready
Call Received
Correct Call
Busy Channel
Transmit
Transmit not allowed
Scanning Normal Scan mode
Priority Look BackScan
Mode
Scan Edit Edit scan list
Priority Edit Priority channel
Edit
Warning
Busy Channel lockout
TX Inhibit
Time-out-timer
Error EEPROM
Unlock

Scan Modes

Scanning is a Dealer programmable feature that allows you to monitor a number of channels or channels within a Group. Your Dealer
will help you define a scanning mode and your channel "scan list" .

Normal Channel Scan

Once the scan list has been established you can initiate scan by press and release of SCAN button.
If a conversation is detected on any of the channels in the scan list, the radio will stop on that channel and you will be able to
hear the conversation. If programmed for normal scan TX you will be able to transmit on that active channel during the pro-
grammable scan delay time. The scan delay time is the amount of time the radio will stay on that channel once activity has
ceased (Dealer programmable, 4-7 seconds is typical). The radio will resume scanning once the scan delay time has expired.
Scanning will continue until the channel is changed.

Priority Channel Scan

A single channel may be programmed as the "Priority" channel. The radio will constantly monitor this channel while scanning
and when the radio has stopped on an active channel. If a call is detected on the "Priority" channel, the radio will automatically
move to, and remain on, the "Priority" channel for as long as the priority conversation takes place. "Priority" channel activity
takes precedence over all other conversations. To activate Priority scan press and release the PSCAN button.
LED color LED Indication
N/A
Orange Channel number
Green Channel number
Orange Channel number
Red Channel number
Red Flashing Alternating UL/Channel number
N/A Group number
Yellow PS/Channel number
Red, Yellow,
Green
Red, Yelow,
Green
orange
N/A _h/rO
N/A
N/A
N/A
Audible Tone
88 Melody
N/A
N/A
N/A
N/A
Two beeps repeated
N/A
N/A
SE N/A
PE N/A
bL Single beep repeated
Two beeps
Pt Single beep/3 beeps
repeated
Er Single beep repeated
UL Two beeps repeated
5