Table of Contents
Advertisement
Microphone Bracket and Hardware
Operating Instructions
If any items are missing, please contact your Dealer or Maxon.
SM-3000 Enduro Series Features
Wideband frequency separation
10 or 40 W programmable output power
Programmable 12.5/25 kHz channel spacing
Channel scan
Priority channel scan
Look back channel
CTCSS/DCS tone signaling
Busy channel lockout
Time-out timer
Scan List Edit
Priority Channel Edit
Description of Radio Components
1) Antenna Receptacle
2) Channel Selector Buttons
3) On/Off - Volume Control
4) Squelch Control
5) R/TX Indicator
6) Priority Indicator
7) Option Indicator
8) Monitor Button
9) Scan Button
10) Priority Button
11) Option Button
12) Speaker
13) Microphone
14) Auxiliary Speaker Connector
15) 15 Pin Interface
16) Power Cord
17) LED Display
Installation Safeguards
Warning - DO NOT install the unit where it would interfere with the proper operation of automatic collision
protection devices (air bags).
Warning - DO NOT install the unit where it would likely cause injury in case of accident.
A.
Select a location for the radio where you can easily see and reach all controls, including microphone.
B.
Using the radio mounting bracket as a template, mark the spots with a pencil where the bracket securing screws
will be located.
Note - Before drilling holes in the vehicle, verify that there is nothing that could be damaged or get in the way by
drilling and putting screws in this location. It is better to use existing passages in the dashboard, trunk, and floor for the
routing cable, thus avoiding excessive drilling.
3
Advertisement
Table of Contents
