2.9
3.5" Storage devices
The server system supports two (2) 3.5-inch storage devices via the assembly module.
To install a 3.5-inch storage device to the right storage bay:
1.
Remove the assembly module from
the chassis. Refer to 2.6.1 Removing
the assembly module for more
information.
2.
Insert and carefully push the storage
device into the bay until its screw
holes align with the holes on the bay.
3.
Secure the storage device with two (2)
screws into the screw holes on the
right side of the assembly module.
4.
Connect the SATA cable to the
SATA connector of the drive.
5.
Connect a SATA power cable from
the power supply to the power
connector of the drive.
6.
Reinstall the assembly module and
front panel cover. Refer to 2.6.2
Replacing the assembly module and
front cover for more information.
2-14
Screw holes
Chapter 2: Hardware Setup