Table of Contents
Advertisement
HD Audio Advanced Configuration
The following item is configurable only when you set Audio Link Mode to [Soundwire].
LAN Wake from DeepSx [Enabled]
This item allows you to enable wake from DeepSx by the assertion of LAN_WAKE# pin.
Configuration options: [Disabled] [Enabled]
SLP_LAN# Low on DC Power [Enabled]
This item allows you to enable or disable SLP_LAN# Low on DC Power.
Configuration options: [Disabled] [Enabled]
Disqualify GBE Disconnect And ModPhy PG [Enabled]
This item allows you to enable or disable Disqualify GBE Disconnect And ModPhy PG.
Configuration options: [Disabled] [Enabled]
4-32
iDisplay Audio Disconnect [Disabled]
Allows you to enable or disable iDisplay Audio Disconnect.
Configuration options: [Disabled] [Enabled]
Codec Sx Wake Capability [Disabled]
Allows you to enable or disable Codec Sx Wake Capability.
Configuration options: [Disabled] [Enabled]
PME Enable [Disabled]
Allows you to enable or disable PME wake of HD Audio controller during
POST.
Configuration options: [Disabled] [Enabled]
Soundwire Buffer RCOMP Setting [Non-ACT Topology]
This item allows you to select the Soundwire Buffer RCOMP Setting.
Configuration options: [Non-ACT Topology] [ACT Topology]
HD Audio Link Frequency [24 MHz]
Allows you to select the HD Audio Link Frequency.
Configuration options: [6 MHz] [12 MHz] [24 MHz]
iDisplay Audio Link Frequency [96 MHz]
Allows you to select the iDisplay Audio Link Frequency.
Configuration options: [48 MHz] [96 MHz]
iDisplay Audio Link T-Mode [2T Mode]
Allows you to select the iDisplay Audio Link T-Mode.
Configuration options: [1T Mode][2T Mode]
Chapter 4: BIOS Setup
Advertisement
Table of Contents
