Connecting Wp820 To Wi-Fi Network; Figure 6 : Wi-Fi Settings - Grandstream Networks WP820 Administration Manual

•
Press to enter the sub menu for Total amount of memory, Available space,
System version, Recovery version, U-boot version, Kernel version, Hardware
version, PN number, Country code and Running time.
•
Press to enter the sub menu for MAC address, IP setting information
(DHCP/Static IP), Ipv4 address, Ipv6 address, Subnet Mask, Gateway; DNS
server and VPN.
•
Press to enter the sub menu for Network SSID, BSSID, IP address, Signal
strength, Connection speed, Channel, Frequency, Tx packets, Tx error packets,
Tx error rate, Tx drop packets, Tx drop rate, Rx packets, Rx error packets, Rx
error rate, Rx drop packets, Rx drop rate.

Connecting WP820 to Wi-Fi Network

The WP820 supports dual-band 802.11a/b/g/n Wi-Fi, please refer to the following steps in order to connect
your WP820 to the Wi-Fi networks:
1. On LCD menu, press Menu key and navigate to Settings → Network Settings → Wi-Fi.
2. Set Wi-Fi to "On" and navigate to "Wi-Fi Settings". A list of Wi-Fi networks will be displayed.
3. Select the desired network to connect to. (Enter the correct password to connect if requested)
WP820 will display Wi-Fi icon on the main LCD menu if the connection to the Wi-Fi network is successful.
Note: If 5GHz and 2.4Ghz are both available, the WP820 will use 5GHz, but it may switch to 2.4GHz if the
signal of 5GHz is poor.
System status:
Network status:
Network Statistics:

Figure 6 : Wi-Fi Settings

WP820 Administration Guide
Version 1.0.1.15
P a g e |
24