Grandstream Networks WP820 Administration Manual page 62

Upload Device Uploads configuration file "cfgMAC.xml" or "cfgwp820.xml" to the phone.
Configuration
Note: Reboot is required to take effect.
Provision
Automatic Upgrade
Automatic Upgrade
Specifies when the firmware upgrade process will be initiated; there are 4 options:
•
•
•
•
Note: Day of week is starting from Sunday. The default setting is "No".
Defines the phone's rules for automatic upgrade. It can be selected from:
Firmware Upgrade
and Provisioning
The default setting is "Always Check at bootup".
Upgrade without
If set to "Yes", the phone will automatically start upgrading after downloading the
Prompt
firmware file. Otherwise, users would need to confirm in the prompted message
on the LCD screen to start upgrading process. The default setting is "Yes".
DHCP Option
Allow DHCP Option Obtains configuration and upgrade server's information from DHCP server using
43 and Option 66 to
options 66 and 43.
Override Server
Note: If DHCP Option 66 is enabled, the phone will attempt downloading the
firmware file from the server URL provided by DHCP, even though Config Server
Path is left blank. Default setting is "Yes".
DHCP Option 120
Configures the phone to allow the DHCP offer message to override the Config
Override SIP Server
Server Path via the Option 120 header. The default setting is "Yes".
Allow DHCP Option
Enables DHCP Option 242. Once enabled, the phone will use the configuration
242 (Avaya IP
info issued by the local DHCP in Option 242 to configure proxy, transport protocol
Phones) and server path. The default setting is "Yes".
Advanced Settings
Disable SIP NOTIFY Disables the SIP NOTIFY Authentication on the phone. If set to "Yes", the phone
Authentication will not challenge NOTIFY with 401. The default setting is "No".
No: The phone will only do upgrade once at boot up.
Check every day: User needs to specify "Hour of the day (0-23)".
Check every week: User needs to specify "Hour of the day (0-23)" and "Day
of the week (0-6)".
Check at a period Time: User needs to specify "Hour of the day (0-23)"
•
Always Check at bootup.
•
Always Check at bootup, when Firmware/Config pre/suffix changes.
•
Skip the Firmware Check.
WP820 Administration Guide
Version 1.0.1.15
P a g e |
62