Table of Contents
Advertisement
WELDEYE
4.3 Alerts shown on Smart Reader
Smart Reader shows alerts for insufficient welder qualifications, wrong filler material, and wrong
shielding gas.
WeldEye compares the range of qualifications on the welder's qualification certificates that are
stored in WeldEye to the qualifications required by the WPS. (The range of qualifications applies
to EN/ISO standards only). If the welder does not have a qualification that matches (or exceeds)
the WPS requirements, the system raises an alert. If the welder decides not to weld, the alert is
not recorded in the cloud service. If the welder does weld despite the alert, the alert is recorded in
the cloud service.
WeldEye also compares the filler material information and shielding gas information that the
welder enters with Smart Reader to the filler and shielding gas defined in the WPS. If these do not
match, the system raises an alert.
In the WeldEye Settings view, you can select whether the system raises alerts for non-conforming
qualifications or not.
OPERATING MANUAL | EN
25
4.3 Alerts shown on Smart Reader
©
KEMPPI | 2017-12-22
Advertisement
Table of Contents
