Table of Contents
Advertisement
WELDEYE
When you finish using the welding machine, log out of Smart Reader so that the following
5.
welding data will not get registered under your name. To log out, select Menu > Log out.
Powering off the Smart Reader will also log out the welder, so that there is no need to
manually log out.
4.2 Identifiers shown on Smart Reader
In the WeldEye cloud service settings, it is possible to control which identifiers Smart Reader
suggests to the welder, that is, which identifiers are displayed on the Smart Reader even before
they are scanned (displayed as grey text). For example, you can select to display the identifiers
that are compulsory for the welder to scan. Other identifiers can still also be scanned.
OPERATING MANUAL | EN
Note: The Weld complete function requires that the Weld barcode has been
scanned. Availability of the Weld Complete function is controlled in WeldEye cloud
service settings.
Note: WeldEye cloud service provides two settings that control logout behaviour:
• Automatic logout: when this setting is enabled in WeldEye, and the welder has
been identified with a barcode, the welder is automatically logged out from the
device after a period of inactivity (non-arc time).
• Remember logged in welder: with this setting, the device remembers the
identifiers that are read, so that the welder, WPS, filler material and other
identifiers are not lost when the device is rebooted.
24
4.2 Identifiers shown on Smart Reader
©
KEMPPI | 2017-12-22
Advertisement
Table of Contents
