Switch Smart Reader On And Off - Kemppi Smart Reader Operating Manual

WELDEYE
Figure 7: Connecting ARC SAW Adapter and Smart Reader to a welding machine

3.3 Switch Smart Reader ON and OFF

If the Smart Reader is directly connected to the welding machine, Smart Reader is automatically
switched on or off when the welding machine is powered on or off.
If Smart Reader is connected to an adapter, it is powered on continuously. To switch Smart Reader
off, unplug the adapter power source.
When Smart Reader is powering on, the booting phase takes a couple of minutes. During
the booting, a logo is displayed. When Smart Reader has started, it asks the user to log in by
scanning a barcode.
Smart Reader's barcode reader is automatically turned off after 2 minutes of inactivity to ensure
the barcode scanner camera's long life. To read barcodes again, press the middle button in Smart
Reader.
Smart Reader has a built-in Li-Ion battery, which is used to gracefully switch off Smart Reader
in the case of power loss. The battery helps keep the device functional if the power is unstable.
Smart Reader stays powered on for up to 2 minutes after the main is powered off. On the
backside of the device, under the plastic cover, there is a red LED light to indicate that the device
is still on.
If Smart Reader's battery has been discharged during a long period of shelving or other non-use
period, Smart Reader needs to be connected and powered on for up to 2 hours for the battery to
become charged and for the Smart Reader to start up.
OPERATING MANUAL | EN 19
3.3 Switch Smart Reader ON and OFF
©
KEMPPI | 2017-12-22