Table of Contents
Advertisement
WELDEYE
Smart Reader needs to be connected to a welding machine to be able to record the measured
current and voltage parameters.The way to connect it depends on the type of welding machine. In
most cases,you need an additional adapter that measures the current and voltage.
With the following welding machines you do not need an adapter, as the machines have native
measurement functionality: Kemppi FastMig KMS/M/Pulse/X, KempArc KMS/Pulse, Kemppi A7
MIG Welder.
Figure 3: Welding machines and accessories for WeldEye usage. * Other brand welding machines can
be any welding machines.
When you are using Smart Reader together with:
• An adapter for measuring voltage and current - connect Smart Reader to the adapter with the
connection cable.
• Kemppi welding machine with Kemppi MSF wire feeder – connect Smart Reader directly to the
power source with the connection cable.
• Kemppi welding machine (with no Kemppi MSF wire feeder) – connect Smart Reader either to
the power source or to the wire feeder, depending on which is more convenient to you.
Note: Smart Reader cannot be connected to Kemppi FastMig KM machines. Smart
Reader is not required for Kemppi X8 MIG Welder, as it has built-in WeldEye functionality.
3.2.1 Connect Smart Reader to Kemppi FastMig KMS/M/Pulse/X,
KempArc KMS/Pulse, Kemppi A7
You do not need an adapter, when you connect Smart Reader to one of these welding machines.
OPERATING MANUAL | EN
3.2 Connect Smart Reader to the welding machine
14
©
KEMPPI | 2017-12-22
Advertisement
Table of Contents
