Connecting the Base Station
Connecting the Base Station
Figure 3 on page 5
a terminal, PC or other host device. Turn off the host before
connection and consult the manual for that equipment (if
necessary) before proceeding. Connect the interface cable
before applying power to the Base Station.
NOTE
Base Station Connection and Routing
1.
Remove the rubber Cable Stopper from the bottom of
the Base Station.
2.
Securely plug the Power Cable and Interface (I/F) Cable
connectors into their respective ports in the underside
of the Base Station.
Cable Stopper
3.
After the cables are plugged in, reinsert the Cable Stop-
per.
4
shows how to connect the Base Station to
The Wasp WWS650 reader can also be Powered
by the Terminal. When powered by the Terminal,
the battery charger is automatically set as Slow
charge.
For some specific interfaces or hosts or lengths of
cable, the use of an external power supply may be
recommended for full recharging capability (see
"Technical Specifications" on page 31
details).
for more
Power Cable
I/F Cable
WWS650