Product Technical Specification
3.3.
VGPIO
The VGPIO output can be used to:
Pull-up signals such as I/Os
•
Supply the digital transistors driving LEDs
•
The VGPIO output is available when the AirPrime HL77xx module is switched ON.
Refer to the following table for the pad description of the VGPIO interface.
Table 11.
VGPIO Pad Description
Pad Number
45
Refer to the following table for the electrical characteristics of the VGPIO interface.
Table 12.
VGPIO Electrical Characteristics
Parameter
Voltage level (V)
Current capability
Active Mode (mA)
Current capability
Sleep Mode (mA)
Rise Time (ms)
3.4.
USIM Interface
The AirPrime HL77xx modules have one physical USIM interface, USIM1, and an optional internal
USIM or eUICC.
The USIM1 interface allows control of a 1.8V USIM and is fully compliant with GSM 11.11
recommendations concerning USIM functions.
The five signals used by the UIM1 are as follows:
•
UIM1_VCC: Power supply
UIM1_CLK: Clock
•
UIM1_DATA: I/O port
•
•
UIM1_RESET: Reset
UIM1_DET/GPIO3: Hardware SIM detection
•
Refer to the following table for the pad description of the USIM1 interface.
41110555
Signal Name
VGPIO
Minimum
Typical
1.7
1.8
-
-
-
-
-
-
Rev 1.0
Detailed Interface Specifications
I/O
Description
O
GPIO voltage output
Maximum
Remarks
1.9
Both active mode and sleep mode
Power management support up to
TBD
(TBD) mA output in Active mode
Power management support up to
TBD
(TBD) mA output in Sleep mode
TBD
Start-Up time from 0V
November 01, 2017
25