Epson TM-L60 Operator's Manual page 69

Paper width:
Roll size:
Specified paper:
Roll paper core:
4.2 Thermal label paper
Paper type:
Paper thickness:
Form:
Paper width:
Roll size:
Specified paper:
Roll paper core:
NOTES: Make sure that it can not be printed in 1.5 mm line spacing in the lower
l
area of the label paper. (See 5-2 Printable Area and Label Paper
Conditions)
It is recommended to issue GS FF command to position the cutter to the
l
base sheet of the label paper in order to cut the label paper easily.
Make sure to issue FF or GS FF command just after sending data per
l
label paper.
Do not use other than specified paper.
l
5. Receive buffer
Either 4 K or 45 bytes is selectable by a DIP switch
60 ± mm
Roll diameter
Taken up paper roll width: 60 ±
Roll paper model No.:
(NAKAGAWA MFG. Co., Ltd.)
[Original paper model No.:TFSOKS-E)
(JUJO PAPER CO., LTD)]
Inside diameter: 12 mm
Outside diameter: 18 mm
Paper should never be pasted to the paper core.
Specified thermal label paper
143 ± 15 µm (total)
Roil paper
60 ± mm
Roll diameter
Taken up paper roll width: 60 ±
Thermal label paper:
(NAKAGAWA MFG. Co., Ltd.)
Original paper model No.: HD75 (JUJO
Inside diameter:
Outside diameter:
Paper should never be pasted to the paper core.
63
Max. ø83 mm
mm
NTP060-80
Max. ø83 mm
mm
NTLO60-80
PAPER CO., LTD)
12 mm
22 mm