Epson TM-L60 Operator's Manual page 35

ESC % n
[Name]
Select/cancels user-defined character set.
[Format] <1B> H <25> H <n>
0
[Range]
[Description] Selects or cancels the user-defined character set.
Only the lowest bit of n is valid.
l
When n = < ******* 1>B, the user-defined character set
is selected.
When n = < ******* 0>B, the user-defined character set
is canceled (and the internal character set is selected.)
The user-defined characters and a down-loaded bit image can
[Notes]
l
not be defined at the same time.
n = 0
[Default]
[Reference] ESC &
ESC & s n m [a[p] s Xa]m-n+l
[Name] Define user-defined characters
[Format] <1B>H<26>H<s><n><m>[<a><p1><p2>---<psXa>]m-n+1
[Range] s = 3
32
0
0
0
[Description] Defines user-defined characters for ANK character codes.
"s" specifies the number of bytes in the vertical direction.
l
. "n" specifies the beginning ASCII code for the definition and "m"
the final code. If only one character is defined, use n = m.
The allowable character code range is from ASCII code <20> H
l
to <7E> H and the maximum number of characters is 95.
"a" specifies the number of dots in the horizontal direction.
l
"p" is the dot data for the characters. The pattern for a dots is in
l
the horizontal direction from the left side. The remaining dot
pattern on the right side is space. The amount of data to be
defined is s X a.
After user-defined characters are defined once, they are avail-
l
able until another definition is made, until ESC @ is executed, or
until the printer is turned off.
[Notes] The user-defined characters and a down-loaded bit image
l
cannot be defined at the same time. If this command is ex-
ecuted, the down-loaded bit image will be cleared.
n 255
n m 126
a 12 (Font A)
a 9 (Font B)
p1 ... psXa 255
29