Epson TM-L60 Operator's Manual page 51

GS :
Set starting/ending of macro definition
[Name]
[Format] <1D>H<3A>H
[Description] Specifies the starting or ending of the macro definition.
If this command is received while defining the macro, it ends the
definition.
[Notes]
l
l
the macro definition is not cleared. Therefore, it is possible to
l
[Default] Macro is not defined.
[Reference] GS
GS <
Initialize printer mechanism
[Name]
[Format] <1D>H<3C>H
[Description] Positions the label for printing.
[Notes]
l
l
l
GS A m n
[Name] Adjust label paper position to start printing
<1D>H<41>H<m><n>
[Format]
[Range]
0
0 n 255
[Description] Sets the label position in terms of adjustment amount against
default position.
If the macro range exceeds 2048 bytes, the exceeds data is not
defined.
Even if the ESC @0 command (initialize the printer) is performed,
include ESC @ in the macro definition.
Normal printing operation is possible while defining the macro.
This command takes effect on the third and following labels.
This is because the difference in detection level between label
and base sheet is determined using the first label on a sheet
and the label length and distance between labels using the sec-
ond label.
Because the maximum label length is 4 inches, any labels ex-
ceeding 4 inches in length will cause error.
The contents set by commands will not change.
m 255
4 5