Epson TM-L60 Operator's Manual page 49

GS FF
[Name] Print and eject label
<1D>H<OC>H
[Format]
[Description] Prints the data in the print buffer on the label and ejects it.
l
l
l
[Notes]
l
l
l
[Reference] FF
G S * n 1 n 2 [ d ] n 1 x n 2 x 8 G S * n 1 n 2 [ d ] n 1 x n 2 x 8
[Name] Define down-loaded bit image
<1D>H<2A>H<n1><n2>[<d]n1Xn2X8
[Format]
[Range]
[Description] Defines a down-loaded bit image with the number of dots speci-
fied by nl and n2.
l
l
l
[Notes]
l
l
[Reference] G S /
Ejects the label until it can be peeled off by fingers.
After ejection, an error LED is lit and waits until the paper feed
switch is pressed.
When the paper feed switch is pressed, it is assumed that the
label has been peeled off, and then paper feeding is performed
in the reverse direction to set the next label at the starting posi-
tion for printing.
After checking the error LED is lit, remove the label and then
press the paper feed switch once.
This command is effective only when "label print" is selected.
A FF or GS FF command must be sent after transmitting print
data for one label.
The number of dots in the horizontal direction is n 1 X 8, and in
the vertical direction is n2 X 8.
"d" specifies the bit image data.
After a down-loaded bit image is defined once, it is available
until another definition is made, until ESC @ is executed, until
ESC & is executed, or the printer is turned off.
The relationship between the bit image data and the transmit-
ted dots is as follows:
The user-defined characters and a down-loaded bit image can-
not be defined at the same time. If this command is executed,
the user-defined characters will be cleared.
43