FUNCTION
ALARM AN
DEFINITION :
HOW TO MODIFY IT :
POSSIBLE VALUES :
EXAMPLE :
NOTE :
PARAMETER
HYSERESIS
Establishes the alarm hysteresis. Alarms switch ON at set point but switch
OFF value depends on the hysteresis setting.
Hysteresis is expressed in Engineering units and is added to low alarm and
subtracted from high alarm set points to establish the alarm release value.
Enter a numeric value. (Up to 3 digits)
[0 ... 999]
With CHG rate type, this parameter is expressed in Engineering units.
7. DETAILED CONFIGURATION
7-17
CLASSIFICATION
!!