Setting The Roll Paper - Sega type twin F355 Owner's Manual

DIP SW SETTING
The Printer has 2 DIP Switches. To avoid
malfunctioning, use the Switches as adjusted
at the time of shipment.

7 -2 SETTING THE ROLL PAPER

The 2 red Lamps at the Rear Cabinet back side flash indicating the PAPER END Error under
normal operation. Prepare the new Roll Paper exclusively used for the product and the Master
Key. To set the Roll Paper, perform Printer's initialization to remove the cause of the error.
Turn off power or enter into the Test Mode to perform the initialization. Explanations for
setting the Roll Paper in cases of power on and off are given as follows. Further, when the Roll
Paper is set after the Printer Kit is installed, performing work with the power off is necessary as
the power is turned off when installing the Kit. The Roll Paper has Marks indicating position in
order to print and cut properly. The Mark indicating the end of paper appears at the end of Roll
Paper. The Printer's Sensor detects the Mark and interprets it as the end of Roll Paper. At the
beginning of Cabinet's installation, the red Lamps light up as the Mark indicating the end of
Paper is not detected.
SETTING THE PAPER WITH THE POWER ON
1
Enter into the TEST Mode and have PRINTER TEST
screen displayed on the monitor. "ERROR!!" next to the
MESSAGE and "PAPER END" next to the WARNING
are displayed on the monitor.
MESSAGE : ERROR !!
ERROR :
WARNING : PAPER END
STATUS :
COUNTER :
2
Unlock with the Master Key and
remove the Printer Door.
3 Draw the ASSY Printer toward you.
PRINTER TEST
INIT
F-FEED
SW1
Setting at the time of shipment
DIP SW
FIG. 7. 2 b
21
SW 2
FIG. 7. 1
Printer Door
FIG. 7. 2 a
ASSY Printer
www.seuservice.com