14 - 4 CLEANING THE MONITOR GLASS
Removing the Monitor Glass requires complicated work. Clean the Front Glass only in the
weekly cleaning. To clean the Reverse Glass of the Monitor and the CRT Surface, removing
the Monitor Glass is required.
FRONT MONITOR GLASS
1
Take out 2 screws to remove the Boss Cover.
2
Take out 10 screws to remove the Control Panel Upper. If it is hard to take out the screws due
to the existence of the Steering Wheel, remove the emblem and the Steering Wheel ahead of
time.
3
Take out 4 screws to remove the Control Panel Bracket Upper.
Take out a total of 6 screws, and remove each of Glass Holder Upper Center, Glass Holder
4
Upper Lower, and Glass Sash.
GLASS SASH
GLASS HOLDER LOWER CENTER
CONTROL PANEL BRACKET UPPER
CONTROL PANEL UPPER
BOSS COVER
TRUSS SCREW(2),black
M4 X 8
5
Take out the Monitor Glass.
www.seuservice.com
TRUSS SCREW(10),black
M4 X 12,flat washer used
FIG. 14. 4 a
FIG 14. 4 b
MONITOR GLASS
54
GLASS HOLDER UPPER CENTER
GLASS SASH
TRUSS SCREW(6 in total),black
M4 X 16,flat washer used
SCREW(4)
M4 X 16,w/flat & spring washers