Clutch Pedal; Removing The Clutch Pedal - Sega type twin F355 Owner's Manual

12. CLUTCH PEDAL

Before starting to work, ensure that the Power SW is OFF. Failure to observe
this can cause electric shock or short circuit.
Use care so as not to damage wirings. Damaged wiring can cause electric
shock or short circuit.
Do not touch undesignated places. Touching places not designated can cause
electric shock or short circuit.
This work should be performed by the Location's Maintenance Man or
Serviceman. Performing work by non-technical personnel can cause electric
shock hazard.
When performing work such as parts replacement other than those specified
in this manual, be sure to contact where you purchased the product from.
Confirm the work procedures and obtain precautions from where you
purchased the product from prior to performing work. Inappropriate parts
replacement and/or installation with erroneous adjustment can cause an
overload or the parts to come into contact, resulting in an electric shock, a
short circuit, and a fire.
If the Clutch Pedal's operation is not satisfactory, the V.R. installation position adjustments or
V.R. replacement is needed. Also, be sure to apply greasing to the V.R. Gear mesh portion and
the 2 Springs once every 3 months.
12 - 1 REMOVING THE CRUTCH PEDAL
1
Turn off power.
2
Take out 4 Hexagon Bolts. At this time, support the Clutch Pedal as taking out the bolts can
cause the Clutch Pedal to fall.
PHOTO 12. 1 a
HEXAGON BOLT (4)
M8 X 30,w/spring washer
41 www.seuservice.com