Introduction; Purpose; Fcc Information And Requirements; Compliance Statement (Part 15.19) - Primex XR Operation Manual

Document: 1014.100
1. I
NTRODUCTION

1.1 Purpose

This manual documents the overall operations of the new XR synchronized clock transmitter system.

1.2 FCC Information and Requirements

1.2.1 Compliance Statement (Part 15.19)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

1.2.2 Warning (Part 15.21)

Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.

1.2.3 Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

1.2.4 FCC Caution Statement

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.

1.2.5 FCC License Requirements

Operation of the XR transmitter requires an FCC operating license which must be applied for by the operator of the
equipment. The XR models with attached whip antennae require a mobile license. Prior to operating the XR
transmitter, an application must be filed with the FCC and a license granted from the FCC. The filing and receipt of
the FCC license should be complete before the transmitter is delivered whenever possible. Please contact Technical
Support at 1-800-404-8112 if you have any questions about licensing.

1.2.6 FCC Part 90 Statement

To comply with FCC's RF exposure limits for general population / uncontrolled exposure, the antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
Confidential Document
New transmitter
Page 3 of 14
ECN: 1.10