Detailed Panel And Menu Operation - Primex XR Operation Manual

Document: 1014.100
•
If an error condition has occurred (the Red LED is flashing) the bottom line will have a scrolling error message
instructing the operator to look at the diagnostic menus or to call Technical Support.

2.3.3 Detailed Panel and Menu Operation

Normal Display – 2 rows of text:
1. Time (HH:MM:SS format) – am or pm on display if in 12 hour format
2. Date (Day of week, month, and year format)
3. Standard time (ST) or Daylight savings time (DT)
4. Time zone (P for Pacific, M for Mountain, C for Central, E for Eastern). Display would read CST for
Central Standard Time and CDT for Central Daylight Savings Time.
5. Antenna symbol when connected to GPS or an R displayed when connected to a repeater
6. Parenthesis when receiving time data
7. Channel #
8. Version #
9. LP when output power is low
10. Any error that causes a flashing Led will pop this message into the bottom line: "Call Tech Support 1-
800-404-8112 or Use Diagnostic Error Codes Menu". This message can be on two lines and flip between
the two lines at 5 second intervals.
Navigation Buttons:
Pressing right arrow button of keypad while in normal display mode opens main menu.
Pressing the right arrow advances to the next level down of menu.
Pressing the left arrow backs out of the menus one level at a time.
Pressing the up and down arrows allows up and down scrolling within a menu.
ENTER Pressing the Enter button while in a menu acts as the Enter button, selecting an option.
Main menu:
2 rows of text including any sub-menu. Can be laid out with more than one menu item on a line if it fits and the text
is understandable. For menus with more than two lines, scrolling up and down will be used to navigate.
1. Whenever a change is being made to a variable, a dialog will open asking yes or no. If the user selects Yes,
the change is made. If no is selected, the menu goes back to its previous location.
2. After inactivity, the menu times out and returns to normal display.
3. Transmitter operation does not stop when navigating through main menu.
4. All values within a menu are dynamically updated when switch settings are changed or conditions change.
Panel Menus:
1. Diagnostic Error Codes
a. Bad output power (will show BCD value in dB here)
i.
1.
b. PLL Diagnostics
i.
c. No GPS or Repeater connected
i.
d. No GPS in 48 Hours
i.
e. VSWR Errors (enabled only for high power versions, not this version)
2. Switch Settings – displays the switch position for the following switches
a. Channel
b. Time Zone
Confidential Document
New transmitter
Clear Error
Yes or NO confirmation after clearing.
Clear Error
1. Yes or NO
Clear Error
1. Yes or NO
Clear Error
1. Yes or NO
i. Clear Error
1. Yes or NO
Page 12 of 14
ECN: 1.10