Table of Contents
Advertisement
LNA Low Noise Amplifier Series
Installation
2.1
Unpacking
Inspect shipping containers for damage. If shipping containers are damaged, keep them until the contents
of the shipment have been carefully inspected and checked for normal operation.
The modulator and manual are packaged in pre-formed, reusable, cardboard cartons containing foam
spacing for maximum shipping protection.
CAUTION
Do not use any cutting tool that will extend more than 1 inch into the container.
This can cause damage to the LNA.
Do these steps:
1.
Cut the tape at the top of the carton indicated by OPEN THIS END.
2.
Remove the cardboard/foam space covering the LNA.
3.
Remove the LNA and manual from the carton.
4.
Save the packing material for storage or reshipment purposes.
5.
Inspect the equipment for any possible damage incurred during shipment.
6.
Check the equipment against the packing list to ensure the shipment is correct.
7.
Refer to the following sections for further installation instructions.
2.2
Installation Tools
No special tools are required.
Chapter 2. INSTALLATION
2–1
Revision 1
MN/LNAS.IOM
Advertisement
Table of Contents
Need help?
Do you have a question about the CLNA and is the answer not in the manual?
Questions and answers