Advertisement
Quick Links
Advertisement
Related Manuals for GDS GDS DRIVE 500
Summary of Contents for GDS GDS DRIVE 500
- Page 1 '^ K > Z/s $%1 1RY 9...
- Page 2 KEd Ed^...
- Page 3 & dz Z hd/KE^ WARNING! FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND INSTALLATION INSTRUCTIONS COULD RESULT IN INJURY OR DEATH AND OR DAMAGE TO PROPERTY AND EQUIPMENT Appropriately licensed and competent personnel only should install the automation equipment. • The operators are designed specifically to open and close sliding gates or doors and should not be used for any •...
- Page 4 /Z/E' Yh/Z D Ed^ - The operator can be connected to a suitable 240v a.c 10A power circuit provided it is done so by a licensed person and rules in AS/NZS 3000:2007 are adhered to. - Solar power can be used to power the operator instead of connecting 240v. This unit can be supplied set up for use with solar power, or by removing the 240vac transformer and following wiring set up for solar connection.
- Page 5 1. Check that the gate runs smoothly throughout its travel and does not bind anywhere. 2. IMPORTANT Ensure gate stops are fitted at the fully open and closed positions. These stops need to be engineered and installed in such a way that they will be strong enough to stop the gate if the limit switch fails to activate.
- Page 7 *Gearbox Oil The gearbox is lubricated with 80W/90 gear oil, which has been added at the factory. Setting gate direction and mounting limit actuators The operator has been set up at the factory to close to the left when looking from the inside of gate looking out, so firstly, if you`re gate closes to the right, swap over the white and brown wires on the “lc”...
- Page 8 With the gate fully closed, hold the limit actuator on top of the rack so the leading edge of the actuator is about 20 to 40mm away from the limit switch. Mark positions to drill 2 x 5mm holes as shown below.
- Page 9 >...
- Page 15 Trouble shooting Eh > > ^ Using the key provided, unlock the clutch release door, then pull the door out to release for manual operation. To lock the gate back into automatic operation, move the gate to around the half way positon, push the lever back in, then lock off in position with the key.
- Page 16 /Ed E E d />^ WARNING! Failure to maintain equipment may result in injury or death and/or damage to property and equipment Recommended maintenance to be performed on the operator and gate are as follows:- Operator performs between 20-49 cycles a day every 6 months Operator performs under 20 cycles a day every 12 months...
- Page 17 RIVE YSTEMS USTRALIA WARRANTS THAT THE GOODS MANUFACTURED BY IT SHALL BE FREE FROM DEFECT IN MANUFACTURE FOR A PERIOD OF MONTHS FROM THE DATE OF INVOICE HOULD ANY FAULT OCCUR WITHIN THAT PERIOD AS A RESULT OF FAULTY WORKMANSHIP OR MATERIALS RIVE YSTEMS USTRALIA AT ITS DISCRETION...
Need help?
Do you have a question about the GDS DRIVE 500 and is the answer not in the manual?
Questions and answers