Memory Module - HP 200 G3 Maintenance And Service Manual

Memory module

1. Prepare the computer for disassembly (see
2. Remove the stand assembly (see
3. Remove the display (see
4. Spread the two retention clips outward (1) until the memory module tilts up at a 45-degree angle.
5. Grasp the edge of the memory module (2), and then gently pull the module out of the slot. Use the same
procedure to remove both memory modules.
CAUTION:
not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
Reverse this procedure to install a memory module.
IMPORTANT:
the bottom memory socket.
Stand assembly on page
Display on page
To prevent damage to the memory module, hold the memory module by the edges only. Do
Memory modules are in a stacked configuration. If only one module is installed it must be in
Preparation for disassembly on page
15).
16).
14).
Memory module 21