Solving Media Card Reader Problems - HP 200 G3 Maintenance And Service Manual

Business pc
Table of Contents

Advertisement

Computer will not boot from hard drive.
Cause
The device is attached to a SATA port that has been hidden in
Computer Setup.
Boot order is not correct.
Hard drive is damaged.
Computer seems to be locked up.
Cause
Program in use has stopped responding to commands.

Solving media card reader problems

Media card will not work in a digital camera after formatting it in Windows.
Cause
By default, Windows will format any media card with a capacity
greater than 32MB with the FAT32 format. Some digital cameras
use the FAT (FAT16 & FAT12) format and can not operate with a
FAT32 formatted card.
A write-protected or locked error occurs when attempting to write to the media card.
Cause
Media card is locked. Locking the media card is a safety feature
that prevents writing to and deleting from an SD/Memory
Stick/PRO card.
Solution
1.
Check SATA cable connections.
2.
Run the Computer Setup utility and ensure Device Available
is selected for the device's SATA port in Advanced > Port
Options.
Run the Computer Setup utility and change boot sequence in
Advanced > Boot Options.
Observe if the front panel Power LED is blinking RED and if any
beeps are heard. See
POST error messages and diagnostic front
panel LEDs and audible codes on page 65
causes for the blinking red and beep codes.
See the Worldwide Limited Warranty for terms and conditions.
Solution
1.
Use the task manager to close programs that do not
respond.
2.
Attempt the normal Windows "Shut Down" procedure. If this
fails, press the power button for four or more seconds to
turn off the power. To restart the computer, press the power
button again.
Solution
Either format the media card in the digital camera or select FAT
file system to format the media card in a computer with Windows.
Solution
If using an SD card, make sure that the lock tab located on
the right of the SD card is not in the locked position. If using a
Memory Stick/PRO card, make sure that the lock tab located on
the bottom of the Memory Stick/PRO card is not in the locked
position.
Solving media card reader problems
to determine possible
51

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents