HP 200 G3 Maintenance And Service Manual page 56

Business pc
Table of Contents

Advertisement

Poor performance.
Cause
Some software applications, especially games, are stressful on
the graphics subsystem.
Cause unknown.
Computer powered off automatically and the Power LED flashes red four times and then white two times.
Cause
Processor thermal protection activated:
A fan may be blocked or not turning.
OR
The heat sink is not properly attached to the processor.
System does not power on and the LEDs on the front of the computer are not flashing.
Cause
System unable to power on.
48
Chapter 6 Troubleshooting without diagnostics
Solution
tray. To prevent these applications from launching at
startup:
In Windows 10:
a.
Type msconfig in the taskbar search box, and then
select msconfig.
b.
On the Startup tab of the System Configuration Utility,
click Open Task Manager.
c.
Select applications that you do not want to launch
automatically, and the click Disable.
1.
Lower the display resolution for the current application or
consult the documentation that came with the application
for suggestions on how to improve performance by
adjusting parameters in the application.
2.
Add more memory.
3.
Upgrade the graphics solution.
Restart the computer.
Solution
1.
Ensure that the computer air vents are not blocked and
the processor cooling fan is running.
2.
Open the access panel, press the power button, and see if
the processor fan (or other system fan) spins. If the fan does
not spin, make sure the fan cable is plugged onto the system
board header.
3.
If fan a plugged in and not spinning, replace it.
Solution
Press and hold the power button for less than 4 seconds. If
the hard drive LED turns white, then:
1.
If equipped with a voltage selector, check that the voltage
selector (located on the rear of the power supply) is set to
the appropriate voltage. Proper voltage setting depends on
your region.
2.
Remove the expansion cards one at a time until the 5V_aux
light on the system board turns on.
3.
Replace the system board.
OR
Press and hold the power button for less than 4 seconds. If
the hard drive LED does not turn on white then:

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents