Camera
1.
Prepare the computer for disassembly (see
2.
Remove the stand assembly (see
3.
Remove the display (see
4.
Lift the tape from on top of the connector on the camera (1).
5.
Disconnect cable from camera (2).
6.
Remove the small Phillips screw that secures the shutter (3).
7.
Lift the shutter off the camera (4).
8.
Remove the two Phillips screws that secure the camera (5).
9.
Lift the camera out of the computer (6).
Reverse this procedure to install the camera.
30
Chapter 4 Removal and replacement procedures
Preparation for disassembly on page
Stand assembly on page
Display on page
16).
14).
15).