Wlan Module - HP 200 G3 Maintenance And Service Manual

WLAN module

CAUTION:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
1. Prepare the computer for disassembly (see
2. Remove the stand assembly (see
3. Remove the display (see
4. Disconnect the antenna cables from the module (1).
NOTE:
5. Remove the Phillips M2.0×3.0 screw (2), and then pull the module out of the socket (3).
Reverse this procedure to reassemble and install the WLAN module.
22 Chapter 4 Removal and replacement procedures
To prevent an unresponsive system, replace the wireless module only with a wireless module
Display on page
Either one or two antenna cables may be connected to the WLAN module.
Preparation for disassembly on page
Stand assembly on page
16).
14).
15).