Boiler Assembly - Riello Condexa PRO NA 75P Installation, Operation And Service Manual

2.6 Boiler assembly

The Condexa PRO NA boilers are supplied complete with a
wall-mounting bracket.
9
CAUTION: Check that the wall on which the appliance is to
be fitted is sufficiently solid and supports safe screw fixing
points.
9
NOTE: The appliance's height must be selected so as to facili-
tate dismantling it and maintaining it.
Model
Condexa PRO NA 75 P
Condexa PRO NA 117 P
For installation:
− Position the bracket (1) onto the wall (2), at the point where
you wish to install the appliance
− Ensure that the bracket is level and mark the points where
the holes for fixing plugs must be drilled
− Drill the holes and insert expansion plugs
− Note: Drill bit size should be 3/8"(10mm) for expansion
plugs (3).
− Fix the bracket to the wall using the screws (4)
− Secure the appliance to the bracket
H
After installing the boiler:
− remove the locking screw at the bottom of the boiler.
− pull the front panel outwards and then to the top to re-
− remove the plostyrene block under heat exchanger.
Height (H) ft
6<H<6.5
6<H<6.5
Close the panelling in reverse order to the one described above.
9
NOTE: Before proceeding with the hydraulic connections the
protection plugs must be removed from the supply, return
and condensate drain piping.
17
3
1
4
move it from points A.
A
INSTALLATION
2
A