Adjust Skid Shoes - Yardworks 270-3250 Owner's Manual

IMPORTANT:
• Never use an oil/gasoline mixture.
• Never use old gas.
• Avoid getting dirt or water in the fuel tank.
• Gas can age in the tank and make it hard to start up the snow thrower in the
future. Never store the snow thrower for extended periods of time with fuel in the
tank.
Adjust Skid Shoes
Adjustment of the skid shoes governs the height above the ground at which the auger
shield operates.
For clearing snow from concrete, asphalt, and other smooth surfaces, it is best to set the
auger shield so that the bottom of the shield scrapes the ground.
For clearing snow from gravel, dirt, and other rough surfaces, it is best to set the auger
shield slightly above the ground to avoid dirt and gravel from entering the auger.
The optimal height of the shield will vary depending on the type of surface being cleared.
Surfaces with larger gravel or stones would require a more raised auger shield.
To adjust the skid shoes:
1. Make sure the snow thrower is on a solid, smooth, and level surface.
2. Place a spacer board on the ground underneath the auger shield between the skid
shoes. The thickness of the board should be the same as the height above the
ground you wish to raise the auger shield to. The skid shoes should not touch the
board (see figure 7).
3. Using a wrench, loosen the four nuts located on the skid shoes (2 nuts on each
skid shoe) and allow the skid shoes to slide to the ground.
4. Re-tighten the nuts on the skid shoes and wheel the snow thrower off of the
spacer board
SPACER
BOARD
A_UST
SKID SHOf
Figure 7- Adjusting Skid Shoes
15