Replacing The Diaphragm - vacuubrand ME 4C NT VARIO Instructions For Use Manual

Replacing the diaphragm

F
E
➨ Unscrew diaphragm support disc (G) with diaphragm (F) and dia-
phragm clamping disc (E).
➨ Check for washers (H) between the diaphragm support disc (G) and
the connecting rod (I) . Do not mix the washers from the different pump
heads, since these are set at the factory to ensure proper pump per-
formance. Make sure that the original number is reassembled at the
individual pump head.
+ Too few washers: The pump will not attain vacuum specification. Too
many washers: Diaphragm clamping disc will hit head cover, causing
noisy operation and possibly causing the pump to seize up.
+ If the old diaphragm is difficult to separate from the diaphragm support
disc, immerse assembly in naphtha or petroleum ether. Do not inhale
vapors!
E
+ Make sure that the square head screw of the diaphragm clamping disc
is correctly seated in the guide hole of the diaphragm support disc.
➨ Lift the diaphragm at the side. Place the diaphragm carefully together
with diaphragm clamping disc and diaphragm support disc in the dia-
phragm key.
+ Avoid damage of the diaphragm; do not excessively bend or crease
the diaphragm too much.
page 115 of 129
+ Check diaphragm (F) for damage and re-
place if necessary.
➨ Lift diaphragm carefully sidewise.
+ Never use a pointed or sharp-edged tool to
lift the diaphragm.
➨ Use the diaphragm key to grip the diaphragm
support disc (G) below the diaphragm.
➨ Position new diaphragm (F) between dia-
F
phragm clamping disc with square head
screw (E) and diaphragm support disc (G).
+ Note: Position diaphragm with pale side
towards diaphragm clamping disc (facing
G
pump chamber).