Valor Portrait 530IN Installation & Owner's Manual page 17

To refi t the window:
DANGER
!
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the bottom of the window
frame is correctly bolted at the bottom;
• Verify that the levers are hooked properly to
the window tabs then;
• Pull out the top and bottom of the window and
release it to insure the springs return it;
• Ensure the window is sealed before operation.
WARNING
!
Failure to install the window correctly can
leak carbon monoxide, aff ect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
1. Place the window centrally against the engine unit
resting it on the support at bottom front of the engine.
2. Pull the clamping bars forward and hook them to
the window frame bracket to secure the top of the
window.
3. Fit the two spring loaded bolts through the bottom of
the window and tighten to secure the bottom of the
window.
Servicing & Maintenance
4. Pull the top of the window forward and release to
ensure the springs return it in position.
5. Similarly check the bottom of the window by pulling
it forward and releasing.
6. Apply fi rm hand pressure around the window frame to
ensure the window is sealed tight against the fi rebox.
7. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
8. Reinstall the front and barrier screen.
F O R S A F E T Y P U R P O S E , ensure the
barrier screen is re-installed on the fi replace
front after maintenance.
OWNER'S
INFORMATION
Safety warning plate
WARNING
!
17