Kenmore 10062603 Owner's Manual page 4

Door AssemblIy Removal
To Remove The Door'
Assemblies (Do NOT remove
the door handles)
Tools Needed; Phil{ips Screwdriver
and a 51,_ Nut Driver
WARNING
TO AVOID THE RISK OF
PERSONAL INJURY OR DEATH
DISCONNECT THE POWER
CORD BEFORE PROCEEDING.
1_Remove the toe grille.
2. Open refrigerator door' to gain
access to door closure screw, See
Figure 6A,
3 Unscrew bottom refrigerator door
closure screw with a Phillips
Screwdriver, See Figure 6A.
(3) SCREWS
SECURE EACH
t[ TOP HINGE
FIGURI
6,, Remove the top hinge covers, See
Figure 9.
F_GURB 8
USE A PHILUPS SCREWDR}VE
REMOVE THE TOP HINGE COY
4
FIGURE 6A
BOTTOM OF
REFR}GERATOR DOOR
4. Disconnect wire harness at
connector, Push lock tab on
underside of connector up and then
pull loose. See Figure 7.
,,
FIGURE 7
CAUTION
To Avoid the Risk Of Personal
Injury Or Property Damage
tape the top of the doors as
shown in Figure&
SCREW I
DRIVER
CAUTION:
The Power
Ce_d must nut
be connected
TOP
COVER
FREEZER DOOR TOP
HINGE IS SHOWN
FIGURE 9
7. Disconnect top hinge freezer door
wires. See Figure 10..
DISCONNECT THE TOP HINGE WIRES
_k WARNINGTHE
POWERCORDMUST B:
DISCONNECTED.
PH]LUPS
SCREW DRIVER
PH{LL}_$ ECRU.
GROUND WiRE