Advertisement
2: LED Indicators
AC: This LED glows green during AC operation.
DC: This LED glows yellow during DC operation.
3: MIC Jack
This 8-pin modular jack accepts the microphone input, and provides a standby control line to activate
the transmitter when using the "BASE" mode of operation. This jack also provides a "Hook" control
line, as well as a "Clone Data" line.
4: BASE/REPEATER Switch
This switch toggles the operating mode between the "REPEATER" mode and the "BASE"
transceiver mode. When the "REPEATER" mode is selected, the LED above it glows green. While
in the "BASE" mode (the green LED is off), you can speak into the microphone to use it as a
transceiver. For normal repeater operation, set this switch to the "REPEATER" mode.
5: LOCAL/REMOTE Switch
This switch toggles the control mode between the "REMOTE" mode and "LOCAL" mode. When the
"LOCAL" mode is selected, the LED above it is off, and the repeater operates according to the
control data programmed into the repeater. While in the "REMOTE" mode, the LED glows green,
and the repeater operates according to the control instructions received from an external device
(connected to the ACC jack on the rear panel).
6: MONITOR Switch
This switch selects the "Squelch" (receiver mute) mode. When the green LED above it is off, "Tone"
or "Coded" squelch is active. When you press this switch momentarily, the green LED will glow
steadily; in this condition, only "noise squelch" is active, and any signal present on the channel will
be heard. If you press and hold this switch for more than 2 second, the green LED will blink and the
squelch will open; in this condition, background noise will be heard if no signal is present.
7: ACCESSORY Switch
This switch can be set up for special applications, such as High/Low power selection, as determined
by your Vertex Standard dealer. The LED above it glows green when this function is activated. For
further details, contact your Vertex Standard dealer.
8: VOL Knob
This control knob adjusts the receiver volume level from the front panel speaker. If desired, this
control knob may be set fully counterclockwise when repeater monitoring is not needed.
9: SQL Knob
This control knob selects the noise squelch threshold level. Set it to a position just above the point
where the BUSY lamp goes out when no signal is present.
10: Channel Selector Buttons (^ and
Press one of these buttons to select the operating channel.
11: Channel Indicator
This seven-segment LED indicates the operating channel number.
12: ANI Display
The ANI LCD (Liquid Crystal Display) indicates the pre-programmed ANI message according to the
ANI code received.
13: TX/BUSY Indicator
The BUSY indicator glows green when the channel is busy, and the TX indicator glows red when the
repeater is transmitting.
14: ANI RESET Button
(1) ANI
Press this button to clear the message on the ANI display, and turn off the LCD backlight.
(2) ENI
Press this button to turn off the Alert tone.
v
)
VXR-7000U FM
REPEATER OPERATING MANUAL
2
Advertisement
