Before Cooking Rice - Tiger JAI-G55S Operating Instructions Manual

3

Before Cooking Rice

1
Measure the rice.
Always use the measuring cup supplied with
the rice cooker (for rinse-free rice as well).
A level filling of rice in the supplied measuring
cup equals about 0.18 L.
● Use the supplied measuring cup for rinse-free rice
as well.
Correct
Incorrect
measurement
measurement
Note
● Always use the specified volume of rice (see
"Specifications" on p.40). Otherwise the rice
may not cook properly.
2
Wash the rice. (This can be
done using the inner pot.)
For rinse-free rice, see p.12.
Note
● Do not use hot water (over 35°C) to wash the
rice or when adding water. It may prevent the rice
from cooking properly.
● Do not apply too much force while washing the
rice. This could damage the inner pot and prevent
rice from cooking properly.
14 14
3
Adjust the water level.
Place the inner pot on a level surface and
adjust the water level to the appropriate line
of the corresponding scale on the inside of
the pot.
● The water level should be selected according
to the type of rice and the selected cooking
menu, but can be fine-adjusted to your personal
preference. (See the guidelines on p.12.)
When cooking 2 cups
of white rice, adjust the
water level to line "2"
on the "Plain" scale.
4
Wipe off any water and rice, etc.
<Outer surface and brim of the inner pot>
<Inside the rice cooker>
Gasket
Heating plate
Hook
button
Upper casing
Center
sensor
Caution
● Be sure to remove any rice or other material adhering
to and around the heating plate, center sensor, upper
casing, and the hook button. (see p.27.)
Adhered material can prevent the lid from closing,
allow steam to leak out during cooking, or cause
the lid to open and the contents to spray out,
resulting in burns or other injuries.
5
Place the inner pot in the rice
cooker.
(1) Turn the inner pot slightly left and right so
it is positioned correctly without any tilt.
(2) Close the lid.
Confirm that the inner lid is
set in place.
(2) Close lid.
Inner pot
(1)
Note
● Make sure the inner pot is set securely into the
rice cooker.
Inner pot
● Be careful not to touch an operation key when
closing the lid.
6
Connect each end of the power
cord to the specified locations.
(1) Connect
Appliance plug
(2) Connect
Power plug
The power will turn on and the symbol will
blink.
Blinks
Note
● If the Keep Warm lamp is on, press the [Keep
Warm/Cancel] key to turn off the lamp.
On Off
15 15