Setting The Timer - Tiger JAI-G55S Operating Instructions Manual

6

Setting the Timer

2
Using the Timer function
You can preset the time that you want cooking
to be actually completed.
• You can preset the time that you want cooking to
actually be complete.
• The preset timer settings will be stored in
memory.
● Example setting: If "Timer" is set to 13:30, cooking
will be completed at 13:30.
1
Check the present time.
• Make sure the present time is correct, or
cooking will not be completed on time. See
p.39 for the procedure to set the present
time.
• The time is displayed in a 24-hour format.
Blinks
18 18
1
3 5
•
6 4
2
Press the [Menu] key to move
the to the desired menu.
• It is not necessary to press the [Menu] key if
the desired menu is already selected.
Blinks Blinks
Beep
3
If you selected the "Porridge"
menu, use the [Hour] and [Min] keys
to set the desired cooking time.
• Each time the [Hour] key is pressed, the
set time will increase by 5 minutes. Each
time the [Min] key is pressed, that time will
decrease by 5 minutes.
• The cooking time can be set to any 5-minute
increment between 40 and 90 minutes.
Increases by 5 min.
Decreases by 5 min.
• The default setting is for 60 minutes. Adjust
as desired.
4
Press the [Timer] key.
Blinks
Beep
Blinks
• The previously preset time will be displayed.
It is not necessary to set the timer again if the
desired completion time is already displayed.
Note
● The Timer function is not available in the following
cases.
• When the "Quick", "Sweet • Mixed", "Slow
Cook", "Cake" menu is selected
• When the preset time is less than that indicated
in the following table. (Each time setting in the
table also applies to rinse-free rice.)
Menu Minimum preset time
Eco 1 h
Plain 1 h
Porridge Cooking time + 1 min
Brown 1 h 30 min
• If you set a time that cannot be registered, and
then try to use the Timer function, rice will be
cooked for the same time as the regular course.
• When "0:00" is blinking on the display
● If the Keep Warm lamp is on, press the [Keep
Warm/Cancel] key to turn off the lamp. (The Timer
function is not available while the Keep Warm
lamp is on.)
● If you do not operate the rice cooker within about
30 seconds after pressing the [Timer] key, an
alarm (3 beeps) will sound.
● If the [Timer] or [Start] key is pressed while the
rice cooker is in a state where the Timer function
is not available, an alarm (3 beeps) will sound.
5
Use the [Hour] and [Min] keys to
set the desired completion time
• The time is displayed in a 24-hour format.
Beep
Blinks
• Press the [Hour] key to change the set time
in 1-hour increments. Press the [Min] key to
change that time in 10-minute increments.
• Hold down the corresponding key to change
the time more rapidly.
Note
● Do not set the timer to more than 12 hours, as it
may result in spoiled rice.
6
Press the [Start] key.
The Timer lamp will turn on and the Timer
function is set.
On
Plain rice
Beep-beep
On
Grains other than
plain rice
Long
Beep
• If you make a mistake or otherwise want
to reset the timer, press the [Keep Warm/
Cancel] key and repeat the procedure from
2
step on p.18.
19 19