Once The Rice Is Done Cooking; Setting The Timer - Tiger JAX-S Operating Instructions Manual

5

Once the Rice Is Done Cooking

Once the final steaming process
begins, the remaining time will
be displayed.
The time until steaming is completed will be
shown on the display in 1-minute increments.
• Steaming times will vary depending upon the
selected menu.
Once the rice is fully cooked,
the Keep Warm function will
automatically engage (the Start
lamp will turn off).
The Keep Warm lamp will turn on and an
alarm (8 beeps) will sound.
On
• If you added ingredients under the "Porridge"
menu, or a longer cooking time is required,
etc., you can set the desired additional
cooking time. Simply press the [Hour] and
[Min] keys once the Keep Warm lamp
turns on, and then press the [Start] key.
The cooking time can be extended up to
15 minutes in increments of 1 minute, a
maximum of 3 times.
• Stir the rice well before reheating.
18 18
1
Stir and loosen the cooked rice.
Be sure to stir and loosen the rice as soon as
cooking is complete.
• Always wear a kitchen mitten, etc., to hold
the pot while stirring.
On
Inner pot
Note
● Be sure to wipe off any hot water that collects on
the upper casing or that runs onto the outside of the
rice cooker when you open the lid immediately after
cooking or while the Keep Warm function is on.
When you are done using the
rice cooker...
Off
1
Press the [KeepWarm/Cancel] key to
turn off the Keep Warm function.
The Keep Warm lamp will turn off.
On Off
Note
● If you disconnect the power plug without
canceling the Keep Warm function, the next
time you turn on the rice cooker, the Keep
Warm light turns on and you cannot cook.
2
Disconnect the power plug and then
the appliance plug.
(1)Disconnect
(2)Disconnect
3
Clean the rice cooker. (See p.30 to
35.)
6

Setting the Timer

4
Condensation
will collect
in the upper
casing.
2
Using the Timer function (Timer 1 /
Timer 2)
You can preset the time that you want cooking
to be actually completed.
• Select either "Timer 1" or "Timer 2" and set the
desired completion time. The start of cooking will
be automatically adjusted so that the operation is
completed at the preset time.
• Each timer can be set to different times. e.g.
"Timer 1" for breakfast and "Timer 2" for dinner.
• The preset timer settings will be stored in
memory.
● Example setting: If "Timer 1" is set to 13:30,
cooking will be completed at 13:30.
1
Check the present time.
Blinks
• See p.42 for the procedure to set the
present time.
2
Press the [Menu] key to select
the desired menu.
The symbol will blink while the menu is
being selected.
1 6
Blinks
• It is not necessary to press the [Menu] key if
the desired menu is already selected.
3
If you selected the "Porridge"
3·5
menu, use the [Hour] and [Min]
keys to set the desired cooking
time.
• Each time the [Hour] key is pressed, the
set time will increase by 5 minutes. Each
time the [Min] key is pressed, that time will
decrease by 5 minutes.
• The cooking time can be set to any 5-minute
increment between 40 and 90 minutes.
Increases by
5 min.
• The default setting is for 60 minutes. Adjust
as desired.
4
Press the [Timer] key to select
either "Timer 1" or "Timer 2".
The selected setting will switch back and forth
between "Timer 1" and "Timer 2" each time the
[Timer] key is pressed.
Both the Timer lamp and the displayed "Timer
1" or "Timer 2" will blink.
Blinks
• The previously preset time will be displayed.
It is not necessary to set the timer again if the
desired completion time is already displayed.
Decreases by
5 min.
Blinks
19 19